Hi.

I'm having a problem with a custom modification to the 1.9.2.7.3c Firmware.

The modification was to add support for the Alcatel Speedtouch USB ADSL Modem.

What is the problem:
1. I loaded up the 1.9.2.7.3c (Normal Firmware HOME BUILT on my system) and this allows me to have telnet access to the wl500g.

2. I load up the modifies 1.9.2.7.3cs (Speedtouch modified Software again built on my system) and even though the TELNET Port is Open and Accepts I can't authenticate with the user/password I previously used. EVERYTHING ELSE SEEMS TO WORK FINE (except the authentication)

What Have I done:
a) Using the WEB Access : Changed both the use and password (restarting the system including a power off restart). NOTHING
b) Loaded a Previously saved configuration (with the correct password and user). NOTHING.
c) Downloaded the Configuration File from the WL500g, and verified the user and password (everything seems fine).

The only potential problem I see is the size of the uploaded firmware (which must also include the firmware for the modem).

Is there anyway to get back the TELNET Access so I can TEST if the FILES are THERE and if I CAN USE THE MODEM?

I can provide all the alterations and prebuilt firmwares, patches.