Checking for 'wait' instruction... unavailable.
POSIX conformance testing by UNIFIX
PCI: Fixing up bus 0
PCI: Fixing up bridge
PCI: Fixing up bus 1
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting ks
devfs: v1.12c (20020818) Richard Gooch (
devfs: boot_options: 0x1
Installing knfsd (copyright (C) 1996
NTFS driver v1.1.22 [Flags: R/O]
i2c-core.o: i2c core module
i2c-dev.o: i2c /dev entries driver module
i2c-core.o: driver i2c-dev dummy driver registered.
i2c-algo-bit.o: i2c bit algorithm module
i2c-proc.o version 2.6.1 (20010825)
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI en
ttyS00 at 0xb8000300 (i
ttyS01 at 0xb8000400 (irq = 0) is a 16550A
Generic MIPS RTC Driver v1.0
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
AEC6265: IDE controller on PCI bus 01 dev 10
PCI: Enabling device 01:02.0 (0000 -> 0003)
AEC6265: chipset revision 16
AEC6265: not 100% native mode: will probe irqs later
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
AEC6265: ROM disabled at 0x00000000
ide2: BM-DMA at 0x0180-0x0187,
ide3: BM-DMA at 0x0188-0x018f, BIOS settings: hdgio, hdhio
PPP generic driver version 2.4.2
PPP Deflate Compression module registered
PPP BSD Compression module registered
SCSI subsystem driver Revision: 1.00
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
Amd/Fujitsu Extended Query Table v1.0 at 0x0040
Physically mapped flash: JEDEC Device ID is 0xC4. Assuming broken CFI table.
Physically mapped flash: Swapping erase regions for broken CFI table.
number of CFI chips: 1
Flash device: 0x200000
Physically mapped flash: cramfs filesystem found at block 1410
Creating 4 MTD partitions on "Physically mapped flash":
0x00000000-0x00040000 : "cfe"
0x00040000-0x001f0000 : "linux"
0x00160b04-0x001f0000 : "rootfs"
0x001f0000-0x00200000 : "nvram"
sflash: found no supported devices
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
PCI: Enabling device 01:03.2 (0000 -> 0002)
ehci_hcd 01:03.2: PCI device 1106:3104
ehci_hcd 01:03.2: irq 2, pci mem c000d000
usb.c: new USB bus registered, assigned b
ECHI PCI device 31041106 found.
ECHI reg 0x49 = 80242720
ECHI reg 0x49 changed to = 80242700
ECHI reg 0x4b = 80242709
ECHI reg 0x4b changed to = 80242729
PCI: 01:03.2 PCI cache line size set incorrectly (0 bytes) by BIOS/FW, correctin
g to 32
ehci_hcd 01:03.2: USB 2.0 enabled, EHCI 1.00, driver 2003-Dec-29/2.4