Проблема с fstab
Значит описываю все подробно:
девайс WL500gP с прошивкой 1.9.2.7-7g
два харда в ЮСБ-боксах
первый два раздела (своп и ext3)
второй один раздел (ext3)
прописал в /etc/fstab как хочу их монтировать
сохранил перезапустил захожу ssh и вижу что все смонтировалось по умолчаниюCode:cat /etc/fstab /dev/scsi/host0/bus0/target0/lun0/part1 none swap sw 0 0 /dev/scsi/host0/bus0/target0/lun0/part2 /tmp/harddisk ext3 rw 0 0 /tmp/harddisk/opt1 /opt ext3 rw 0 0 /dev/scsi/host1/bus0/target0/lun0/part1 /tmp/harddisk/ARHIV ext3 rw 0 0и своп не подключен
в постбут ничего криминального нетCode:mount /dev/root on / type squashfs (ro) none on /dev type devfs (rw) proc on /proc type proc (rw) ramfs on /tmp type ramfs (rw) usbfs on /proc/bus/usb type usbfs (rw) /dev/discs/disc0/part2 on /tmp/harddisk type ext3 (rw,noatime) /dev/discs/disc1/part1 on /tmp/harddisk/part1 type ext3 (rw,noatime)
вот кусок логаCode:cat /usr/local/sbin/post-boot #!/bin/sh dropbear -p 12121 insmod scsi_mod insmod sd_mod insmod usb-storage
какие будут мысли? где причина зарыта?Code:cat /tmp/syslog.log вырезано Jan 1 00:00:03 kernel: usb.c: registered new driver usbdevfs Jan 1 00:00:03 kernel: usb.c: registered new driver hub Jan 1 00:00:03 kernel: usb-uhci.c: $Revision: 1.275 $ time 10:25:12 Jun 17 2006 Jan 1 00:00:03 kernel: usb-uhci.c: High bandwidth mode enabled Jan 1 00:00:03 kernel: PCI: Enabling device 01:03.0 (0000 -> 0001) Jan 1 00:00:03 kernel: ECHI PCI device 30381106 found. Jan 1 00:00:03 kernel: UCHI reg 0x41 = 10 Jan 1 00:00:03 kernel: UCHI reg 0x41 changed to = 0 Jan 1 00:00:03 kernel: usb-uhci.c: USB UHCI at I/O 0x100, IRQ 2 Jan 1 00:00:03 kernel: usb-uhci.c: Detected 2 ports Jan 1 00:00:03 kernel: usb.c: new USB bus registered, assigned bus number 1 Jan 1 00:00:03 kernel: hub.c: USB hub found Jan 1 00:00:03 kernel: hub.c: 2 ports detected Jan 1 00:00:03 kernel: PCI: Enabling device 01:03.1 (0000 -> 0001) Jan 1 00:00:03 kernel: ECHI PCI device 30381106 found. Jan 1 00:00:03 kernel: UCHI reg 0x41 = 10 Jan 1 00:00:03 kernel: UCHI reg 0x41 changed to = 0 Jan 1 00:00:03 kernel: usb-uhci.c: USB UHCI at I/O 0x120, IRQ 2 Jan 1 00:00:03 kernel: usb-uhci.c: Detected 2 ports Jan 1 00:00:03 kernel: usb.c: new USB bus registered, assigned bus number 2 Jan 1 00:00:03 kernel: hub.c: USB hub found Jan 1 00:00:03 kernel: hub.c: 2 ports detected Jan 1 00:00:03 kernel: usb-uhci.c: v1.275:USB Universal Host Controller Interface driver Jan 1 00:00:04 kernel: PCI: Enabling device 01:03.2 (0000 -> 0002) Jan 1 00:00:04 kernel: ehci_hcd 01:03.2: PCI device 1106:3104 Jan 1 00:00:04 kernel: ehci_hcd 01:03.2: irq 2, pci mem c00ac000 Jan 1 00:00:04 kernel: usb.c: new USB bus registered, assigned bus number 3 Jan 1 00:00:04 kernel: ECHI PCI device 31041106 found. Jan 1 00:00:04 kernel: ECHI reg 0x49 = 80010f20 Jan 1 00:00:04 kernel: ECHI reg 0x49 changed to = 80010f00 Jan 1 00:00:04 kernel: ECHI reg 0x4b = 80010f09 Jan 1 00:00:04 kernel: ECHI reg 0x4b changed to = 80010f29 Jan 1 00:00:04 kernel: PCI: 01:03.2 PCI cache line size set incorrectly (0 bytes) by BIOS/FW, correcting to 32 Jan 1 00:00:04 kernel: ehci_hcd 01:03.2: USB 2.0 enabled, EHCI 1.00, driver 2003-Dec-29/2.4 Jan 1 00:00:04 kernel: hub.c: USB hub found Jan 1 00:00:04 kernel: hub.c: 4 ports detected Jan 1 00:00:04 kernel: usb.c: registered new driver usblp Jan 1 00:00:04 kernel: printer.c: v0.13: USB Printer Device Class driver Jan 1 00:00:04 kernel: vlan1: Setting MAC address to 00 02 44 05 8a a5. Jan 1 00:00:04 kernel: vlan1: add 33:33:00:00:00:01 mcast address to master interface Jan 1 00:00:04 kernel: vlan1: add 33:33:ff:05:8a:a5 mcast address to master interface Jan 1 00:00:04 kernel: vlan1: add 01:00:5e:00:00:01 mcast address to master interface Jan 1 00:00:04 kernel: hub.c: connect-debounce failed, port 1 disabled Jan 1 00:00:05 kernel: hub.c: new USB device 01:03.2-1, assigned address 2 Jan 1 00:00:05 kernel: usb.c: USB device 2 (vend/prod 0x67b/0x2507) is not claimed by any active driver. Jan 1 00:00:05 kernel: hub.c: new USB device 01:03.2-2, assigned address 3 Jan 1 00:00:05 kernel: usb.c: USB device 3 (vend/prod 0x5e3/0x702) is not claimed by any active driver. Jan 1 00:00:06 dropbear[108]: Running in background Jan 1 00:00:06 kernel: SCSI subsystem driver Revision: 1.00 Jan 1 00:00:06 kernel: Initializing USB Mass Storage driver... Jan 1 00:00:06 kernel: usb.c: registered new driver usb-storage Jan 1 00:00:06 kernel: scsi0 : SCSI emulation for USB Mass Storage devices Jan 1 00:00:06 kernel: Vendor: ST380011 Model: A Rev: 3.06 Jan 1 00:00:06 kernel: Type: Direct-Access ANSI SCSI revision: 02 Jan 1 00:00:06 kernel: Attached scsi disk sda at scsi0, channel 0, id 0, lun 0 Jan 1 00:00:06 kernel: SCSI device sda: 156301488 512-byte hdwr sectors (80026 MB) Jan 1 00:00:06 kernel: Partition check: Jan 1 00:00:06 kernel: p1 p2 Jan 1 00:00:06 kernel: scsi1 : SCSI emulation for USB Mass Storage devices Jan 1 00:00:06 kernel: Vendor: ST316002 Model: 3A Rev: 0811 Jan 1 00:00:06 kernel: Type: Direct-Access ANSI SCSI revision: 02 Jan 1 00:00:06 kernel: Attached scsi disk sdb at scsi1, channel 0, id 0, lun 0 Jan 1 00:00:06 kernel: SCSI device sdb: 312579695 512-byte hdwr sectors (160041 MB) Jan 1 00:00:06 kernel: p1 Jan 1 00:00:06 kernel: USB Mass Storage support registered. Jan 1 00:00:15 kernel: VFS: Can't find ext3 filesystem on dev sd(8,0). Jan 1 00:00:15 kernel: MSDOS FS: Using codepage 950 Jan 1 00:00:15 kernel: MSDOS FS: IO charset cp950 Jan 1 00:00:15 kernel: FAT: bogus logical sector size 64543 Jan 1 00:00:15 kernel: VFS: Can't find a valid FAT filesystem on dev 08:00. Jan 1 00:00:15 kernel: FAT: freeing iocharset=cp950 Jan 1 00:00:15 kernel: FAT: bogus logical sector size 64543 Jan 1 00:00:15 kernel: VFS: Can't find a valid FAT filesystem on dev 08:00. Jan 1 00:00:15 kernel: VFS: Can't find ext3 filesystem on dev sd(8,1). Jan 1 00:00:15 kernel: MSDOS FS: Using codepage 950 Jan 1 00:00:15 kernel: MSDOS FS: IO charset cp950 Jan 1 00:00:15 kernel: FAT: Did not find valid FSINFO signature. Jan 1 00:00:15 kernel: Found signature1 0x0 signature2 0x0 sector=4. Jan 1 00:00:15 kernel: VFS: Can't find a valid FAT filesystem on dev 08:01. Jan 1 00:00:15 kernel: FAT: freeing iocharset=cp950 Jan 1 00:00:15 kernel: FAT: Did not find valid FSINFO signature. Jan 1 00:00:15 kernel: Found signature1 0x0 signature2 0x0 sector=4. Jan 1 00:00:15 kernel: VFS: Can't find a valid FAT filesystem on dev 08:01. Jan 1 00:00:15 kernel: NTFS: Invalid $Mft record 0 Jan 1 00:00:15 kernel: kjournald starting. Commit interval 5 seconds Jan 1 00:00:15 kernel: EXT3-fs warning: maximal mount count reached, running e2fsck is recommended Jan 1 00:00:15 kernel: EXT3 FS 2.4-0.9.19, 19 August 2002 on sd(8,2), internal journal Jan 1 00:00:15 kernel: EXT3-fs: mounted filesystem with ordered data mode. Jan 1 00:00:15 USB storage: ext3 fs mounted to /tmp/harddisk Jan 1 00:00:15 kernel: VFS: Can't find ext3 filesystem on dev sd(8,16). Jan 1 00:00:16 kernel: MSDOS FS: Using codepage 950 Jan 1 00:00:16 kernel: MSDOS FS: IO charset cp950 Jan 1 00:00:16 kernel: FAT: bogus logical sector size 0 Jan 1 00:00:16 kernel: VFS: Can't find a valid FAT filesystem on dev 08:10. Jan 1 00:00:16 kernel: FAT: freeing iocharset=cp950 Jan 1 00:00:16 kernel: FAT: bogus logical sector size 0 Jan 1 00:00:16 kernel: VFS: Can't find a valid FAT filesystem on dev 08:10. Jan 1 00:00:16 kernel: kjournald starting. Commit interval 5 seconds Jan 1 00:00:16 kernel: EXT3 FS 2.4-0.9.19, 19 August 2002 on sd(8,17), internal journal Jan 1 00:00:16 kernel: EXT3-fs: mounted filesystem with ordered data mode. Jan 1 00:00:16 USB storage: ext3 fs mounted to /tmp/harddisk/part1
