Hallo zusammen,
ich wollte ebenfalls ein LCD-Modul an meinen WL500w anschließen.
Folgende Problematik ereilt mich beim compilieren von LCD4linux.
Aktuelle Sourcen vom SVN-Repository geholt.
./configure
make
make bricht mit folgender Fehlermeldung ab:
make
CDPATH="${ZSH_VERSION+.}:" && cd . && /opt/bin/bash /tmp/harddisk/work/lcd4linux/missing --run aclocal-1.11 -I m4
/tmp/harddisk/work/lcd4linux/missing: line 54: aclocal-1.11: command not found
WARNING: `aclocal-1.11' is missing on your system. You should only need it if
you modified `acinclude.m4' or `configure.in'. You might want
to install the `Automake' and `Perl' packages. Grab them from
any GNU archive site.
cd . && /opt/bin/bash /tmp/harddisk/work/lcd4linux/missing --run automake-1.11 --gnu
/tmp/harddisk/work/lcd4linux/missing: line 54: automake-1.11: command not found
WARNING: `automake-1.11' is missing on your system. You should only need it if
you modified `Makefile.am', `acinclude.m4' or `configure.in'.
You might want to install the `Automake' and `Perl' packages.
Grab them from any GNU archive site.
CDPATH="${ZSH_VERSION+.}:" && cd . && /opt/bin/bash /tmp/harddisk/work/lcd4linux/missing --run autoconf
Unrecognized character \x02 at /opt/lib/perl5/5.8.8/mipsel-linux/Data/Dumper.pm line 631.
Compilation failed in require at /opt/share/autoconf/Autom4te/C4che.pm line 33.
BEGIN failed--compilation aborted at /opt/share/autoconf/Autom4te/C4che.pm line 33.
Compilation failed in require at /opt/bin/autom4te line 38.
BEGIN failed--compilation aborted at /opt/bin/autom4te line 38.
make: *** [configure] Error 1
bevor ich Unwissender groß rumbastel und versuche hab ich mich entschlossen nach Hilfe zu Fragen.
Jemand einen Ansatzpunkt für mich?
Grüße
Smuggler
Router: WL-500w@128MB Ram
Firmware: WL500W-1.9.2.7-rtn-r2411