Hi there is an new oleg firmware available. You can download this firmware by this link: http://oleg.wl500g.info/188.8.131.52-8/
Did you tested it ?
What are adbantages upgrading ?
This is the firmware I'm waiting for!
* Changed connection tracking TCP timeout to 6 hours vs. 5 days
This will solve tcp connection run out problem when running P2P programs!
amule, enhanced-ctorrent.... will back to normal.
Thanks alien433, and also oleg's effort.
Can I save my 500gP 184.108.40.206-7g config and flashfs files from web interface, upgrade firmware and then upload back previous settings ?
I performed an update yesterday. The settings are preserved. However, you should save the flashfs files before the upgrade, since it won't be saved.
Please help me! Can i upgrade the firmware from 220.127.116.11-7g to 18.104.22.168-8 and dont lost all my configurations, programs, and so on? I have installed many programs to my ASUS, it works well, and i dont want to lose this configuration... so, can i do upgrade and i have no problems after that?
No joy for my 500gP.
After upgrade 22.214.171.124.7g -> 126.96.36.199.8, USB flash drives can no longer be detected (boot time). Have tried two different USB2.0 pen-drives with no luck.
188.8.131.52-8 LOG [ERR]
Jan 1 01:02:20 kernel: usb.c: USB disconnect on device 01:03.2-1 address 2
Jan 1 01:02:22 kernel: hub.c: new USB device 01:03.2-2, assigned address 3
Jan 1 01:02:22 kernel: usb.c: USB device 3 (vend/prod 0x90c/0x1000) is not claimed by any active driver.
184.108.40.206-7g LOG [OK]
Jan 1 01:00:07 kernel: Initializing USB Mass Storage driver...
Jan 1 01:00:07 kernel: usb.c: registered new driver usb-storage
Jan 1 01:00:07 kernel: scsi0 : SCSI emulation for USB Mass Storage devices
Jan 1 01:00:08 kernel: Vendor: USB 2.0 Model: Flash Disk Rev: 3000
Jan 1 01:00:08 kernel: Type: Direct-Access ANSI SCSI revision: 02
Is it global probem?, any ideas? I have rolled back to 220.127.116.11 by now.
I'm using a wl-500Gp version 1.0
I get a bad Wi-Fi signal, using this firmware. Connection drops from time to time (signal is 35-40Db less than before, according to NetStumbler).
Original FW gives the same bad signal, DD-WRT gives me the strongest signal. For the support of the USB ports i need Oleg's.
So I did some research and used wl command's:
wl antdiv 0
wl txant 0
gives same bad signal, changing numbers into 1 or 3 give me the old (+35/40Db) stronger signal!
I'm a bit of a Linux noob so i have a question: How do I save the above commands in my NVRAM?
you may put them in the post-boot file
With this fw, you can't disable wireless
Can't you really disable wi-fi or simply the led stay on even if wi-fi is disabled ?
It's looks like false alarm, I'll try it when I get back my laptop. Probably only led