I got better: Using the ide-mod.o and ide-disk.o from the compiled hdd firmware, I can insmod.
I still cannot do an insmod ide-probe-mod.o as I get the HDD light always on, and the wlhdd hang from that.
I don't know if the first 2 mods are enough to get access to hdd. I think I have to try a makedevs? but I cannot find the syntax for the command. Is there a way to see if I have access to hd if I don't have any /dev/hdxx ?
EDIt: I can make the devs, but it's not enough
If I insmod the compiled ide-probe-mod.o, i get the error "segmentation fault", probably because they haven't been compiled at the same time. I have this module marked as loading if I lsmod.
Here are some other result:
Code:
[admin@(none) ide]$ cat drivers
ide-disk version 1.12
[admin@(none) ide]$ cat pdc202xx
PROMISE Ultra series driver Ver 1.20.0.7 2002-05-23 Adapter: Ultra100 on M/B
--------------- Primary Channel ---------------- Secondary Channel -------------
enabled enabled
66 Clocking disabled disabled
Mode PCI PCI
--------------- drive0 --------- drive1 -------- drive0 ---------- drive1 ------
DMA enabled: no no no no
UDMA Mode: 0 0 0 0
PIO Mode: 0 0 0 0
I have also a ide device in my dev folder but nothing else