back to english :)
I have wl-hdd with the latest firmware (1.9.2.7-9).
When I plug the k8055 board I get:
hub.c: new USB device 00:04.0-1, assigned address 2
usb.c: USB device not accepting new...
Type: Posts; User: vladut
back to english :)
I have wl-hdd with the latest firmware (1.9.2.7-9).
When I plug the k8055 board I get:
hub.c: new USB device 00:04.0-1, assigned address 2
usb.c: USB device not accepting new...
oleg firmware is not compatible with wl-330ge!
It seems that version 2011 is all-in-one.
I have the toolchain from the original drivers CD but that is for version 2009.
Or it can be the same toolchain.
What about custom firmware support for this device?
It has an bcm5354kfbg processor and the cd came with the gpl sources (toolchain.tgz + WL330gE2009_GPL.tgz).
Can anyone (oleg :) ) integrate it...
Try this:
http://www.sprayfly.com/wiki/User_Management_Guides
I have discovered one thing:
For nfs mounting to work, portmap must be started on the NFS client.
If you don't start it (or if you can not start it because it is not there - like in dreambox dm500)...
Same problem here.
I have wl-hdd and I was installed stuff on it (flash with wl500g-clear-nvram.trx then with WLHDD-1.9.2.7-7g.trx) at work (net 192.168.0.0/24).
I did not have a chance to test...
I want to forward the port 8080 from wan to lan at one ip address but another port
(194.x.x.x:8080 -> 192.168.0.10:80).
How it can be done from admin interface?
I think that is possible from the...
mke2fs is the command for formating (mkswap the for swapfile)
Use -j switch when formating:
mke2fs -j /dev/ide/host0/bus0/target0/lun0/part2
It may work if you use "-t ext3" switch:
mount -t ext3 /dev/scsi/host0/bus0/target0/lun0/part2 /opt
It seems that you are trying to mount the swap partition.
TRY:
[admin@banana /]$ mount /dev/ide/host0/bus0/target0/lun0/part2 /opt