I have a uart/driver with a 1.8432MHZ xtal.
I can see the linux boot process, but I can't get the PMON boot. Neither if I press reset during power up, in this case I didn't get a byte.
The PC terminal I configure it with:
setserial /dev/ttyS0 divisor 7
setserial /dev/ttyS0 spd_cust
stty speed 38400 < /dev/ttyS0
To get the custom 16457 baud rate.
This is what I get:
CPU revision is: 00024000
Loading BCM4710 MMU routines.
Primary instruction cache 8kb, linesize 16 bytes (2 ways)
Primary data cache 4kb, linesiôe 16 bytes (2 ways)
Linux version 2.4.20 (root@localhost.localdomain) (gcc version 3.2.3 with Broadcom m4
Determined physical RAM map:
memory: 01000000 @ 00000000 (usable)
On node 0 totalpages: 4096
...
Any ideas?