View RSS Feed

Omega

USB LCD (OLED) Asus

Rating: 6 votes, 5.00 average.
Quote Originally Posted by Omega View Post
Quote Originally Posted by LnrMn View Post
Vogue/Playboy .


http://pchelnikov.ru/reportage/2010/...eMag/anfas.jpg

:

: Ingenic JZ4725B
ftp://ftp.ingenic.cn/2soc/Jz4725B_ds.pdf

  • 360MHz XBurst CPU
  • XBurst RISC instruction set to support Linux and WinCE
  • XBurst SIMD instruction set to support multimedia acceleration
  • LCD controller: 18bits, support both RGB and MCU interface, 1280*1024 resolution
  • Interrupt Controller, Timer, WDT, PWM, I2C interface, UART (Arduino)
  • USB 2.0 Device controller, high speed, 1 port
  • 2 MMC/SD/SDIO controller

: HYB39S256160DT-7 32 B SDRAM 16Mx16
Datasheet http://rghost.ru/3392953 http://rghost.ru/3392961

: Samsung K9G8G08U0A-PCB0
http://www.samsung.com/global/system...Nand_Flash.pdf



Code:
$ sudo ../xburst-tools/usbboot/src/usbboot -f /etc/xburst-tools/usbboot.cfg -1 ./fw.bin -2 ./usb_boot.bin -c boot
usbboot - Ingenic XBurst USB Boot Utility
 2009 Ingenic Semiconductor Inc., Qi Hardware Inc., Xiangfu Liu, Marek Lindner
This program is Free Software and comes with ABSOLUTELY NO WARRANTY.

Now checking whether all configure args valid: YES
Current device setup information:
Crystal work at 12MHz, the CCLK up to 96MHz and PMH_CLK up to 32MHz
SDRAM Total size is 32 MB, work in 4 bank and 16 bit mode
Nand page per block 64, Nand page size 4096, ECC offset in OOB 12, bad block offset in OOB 0, bad block page 127, use 1 plane mode
 Execute command: boot 
 CPU data: JZ4750V1
 CPU not yet booted, now booting...
 Loading stage1 from './fw.bin'
 Download stage 1 program and execute at 0x80002000
 CPU data: JZ4750V1
 Loading stage2 from './usb_boot.bin'
 Download stage 2 program and execute at 0x81c00000
 CPU data: JZ4750V1
 CPU data: Boot4750
 Booted successfully!
 CPU data: Boot4750
 Configuring XBurst CPU succeeded.


$ sudo ../xburst-tools/usbboot/src/usbboot -f /etc/xburst-tools/usbboot.cfg -1 ./fw.bin -2 ./usb_boot.bin -c "nquery 0 0"
usbboot - Ingenic XBurst USB Boot Utility
 2009 Ingenic Semiconductor Inc., Qi Hardware Inc., Xiangfu Liu, Marek Lindner
This program is Free Software and comes with ABSOLUTELY NO WARRANTY.

Now checking whether all configure args valid: YES
Current device setup information:
Crystal work at 12MHz, the CCLK up to 96MHz and PMH_CLK up to 32MHz
SDRAM Total size is 32 MB, work in 4 bank and 16 bit mode
Nand page per block 64, Nand page size 4096, ECC offset in OOB 12, bad block offset in OOB 0, bad block page 127, use 1 plane mode
 Execute command: nquery 0 0 
 CPU data: Boot4750
 ID of No.0 device No.0 flash: 
 Vendor ID    :0xec 
 Product ID   :0xd3 
 Chip ID      :0x14 
 Page ID      :0xa5 
 Plane ID     :0x64
: http://www.youtube.com/watch?v=9-PNe1K3ifc&NR=1

.. ...

Comments