pinocten
30-09-2006, 06:10
I've downloaded the latest official firmware (FW) for the router. I unpack it, upload the trx-file to the modem through the browser and the router disconnects. After 10-12 minutes the router shows up in the Zero Configuration, but I cant connect to it.
The only solution is to power off and on the router and then I can connect to it again. And here it tells me that it still runs with the previous FW 1.9.6.7.
I've tried with firefox, internet explorer, wireless and with cable, but no luck.
Any suggestions?
The leds just doesnt flash or anything unusual else. Is this normal when updating the FW or which signs should I look out for?
The only solution is to power off and on the router and then I can connect to it again. And here it tells me that it still runs with the previous FW 1.9.6.7.
I've tried with firefox, internet explorer, wireless and with cable, but no luck.
Any suggestions?
The leds just doesnt flash or anything unusual else. Is this normal when updating the FW or which signs should I look out for?