harry66
11-12-2004, 09:07
Hi,
Did a search for this but cant find the answer...
I have upgraded to the new 1927 firmware and now whenever I reset the WL500g it prints a simple status page on my printer attached to the paraller port. This is annoying as I need to reset the wl500g every now and then and think its a waste of paper. The text printed is 'PARPORT: ML-1250'
I have been through all the options on the config pages but cant find anything to turn this off - would be great if someone can point me in the right direction.
Note that I am running the device in simple access point mode.
Also, I noticed that with the new firmware I can now see many more options eg the FTP stuff even when I am in simple Access Point mode - does this mean that the new firmware support FTP to a USB drive even in AP mode?
Thanks in advance for the answers...
Did a search for this but cant find the answer...
I have upgraded to the new 1927 firmware and now whenever I reset the WL500g it prints a simple status page on my printer attached to the paraller port. This is annoying as I need to reset the wl500g every now and then and think its a waste of paper. The text printed is 'PARPORT: ML-1250'
I have been through all the options on the config pages but cant find anything to turn this off - would be great if someone can point me in the right direction.
Note that I am running the device in simple access point mode.
Also, I noticed that with the new firmware I can now see many more options eg the FTP stuff even when I am in simple Access Point mode - does this mean that the new firmware support FTP to a USB drive even in AP mode?
Thanks in advance for the answers...